On-Vehicle Inspection [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECT SHIFT LEVER POSITION
1. When moving the shift lever from P to R with the power switch on (IG) and the brake pedal depressed, check that the shift lever moves smoothly and correctly into position.
2. Start the engine and check that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.
  If the operation is not as specified, inspect the shift lever position sensor or adjust the transmission control cable assembly.
INSPECT SHIFT LOCK OPERATION
1. Move the shift lever to P.
2. Turn the power switch off.
3. Check that the shift lever cannot be moved from P to any other position.
4. Turn the power switch on (IG), depress the brake pedal, and check that the shift lever can be moved from P to any other position.
  If the operation is not as specified, inspect the transmission floor shift assembly.
  
  Refer to INSPECTION [02/2014 - ]
INSPECT SHIFT LOCK RELEASE BUTTON OPERATION
1. Turn the power switch off.
2. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever cap from the transmission floor shift assembly.
  NOTE:
  Be careful not to damage the shift lever cap and transmission floor shift assembly.
3. When moving the shift lever with the shift lock release button pressed, check that the shift lever can be moved from P to any other position.
  If the operation is not as specified, inspect the transmission floor shift assembly.
  
  Refer to INSPECTION [02/2014 - ]