LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 110 (Front Suspension (Service Information) (Hybrid)) >> Front Stabilizer Bar >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE 

    Refer to REMOVAL [02/2014 - 11/2015] , or refer to REMOVAL [11/2015 - 11/2016]

  2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH 
    1. Remove the nut and front stabilizer link assembly LH from the front stabilizer bar.
      GTY425860Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

  3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH 

    HINT: 

    Perform the same procedure as for the LH side.

  4. REMOVE FRONT NO. 1 STABILIZER BRACKET LH 
    1. Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
      GTY425867Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE FRONT NO. 1 STABILIZER BRACKET RH 

    HINT: 

    Perform the same procedure as for the LH side.

  6. REMOVE FRONT STABILIZER BAR 
    1. Remove the front stabilizer bar with 2 front No. 2 stabilizer brackets and 2 front No. 1 stabilizer bar bushings from the front frame assembly.
  7. REMOVE FRONT NO. 2 STABILIZER BRACKET LH 
    1. Remove the front No. 2 stabilizer bracket LH from the front No. 1 stabilizer bar bushing.
      GTY425868Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE FRONT NO. 2 STABILIZER BRACKET RH 

    HINT: 

    Perform the same procedure as for the LH side.

  9. REMOVE FRONT NO. 1 STABILIZER BAR BUSHING 
    1. Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.
scientia non olet · About LEMON Manuals