LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System (2GR-FE) (Service Information) (Except Hybrid) >> Starter >> Installation [12/2013 - 11/2016] >> Procedure

Installation [12/2013 - 11/2016]: Procedure

  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Connect the starter assembly connector.
    3. Connect terminal 30 with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    4. Close the terminal cap.
  2. INSTALL BATTERY 

    Refer to PROCEDURE - Step 53

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 54

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 55

  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 3

  6. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 57

  7. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 84

  8. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016]

scientia non olet · About LEMON Manuals