Brake Actuator (Skid Control ECU) Communication Stop Mode [12/2013 - 11/2016]: Procedure

1. Disconnect the cable from the negative (-) battery terminal.
2. Disconnect the A47 skid control ECU (brake actuator assembly) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly))

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A47-25 (CANH) - A47-14 (CANL)	Cable disconnected from negative (-) battery terminal	54 to 69 Ω

Result: 

NG 

REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)) 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly))

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A47-1 (GND1) - Body ground	Cable disconnected from negative (-) battery terminal	Below 1 Ω

2. Reconnect the cable to the negative (-) battery terminal.
3. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly))

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   A47-34 (IG1) - Body ground	Ignition switch ON	11 to 14 V

Result: 

OK 

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY). Refer to  REMOVAL [12/2013 - 11/2016] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)