DTC C1ABB: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete [12/2013 - ]: Description
This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABB | Blind Spot Monitor Master Module Beam Axis Inspection Incomplete | A beam axis inspection has not been performed | Blind spot monitor sensor LH |