DTC C1AB6: Blind Spot Monitor Master Module [12/2013 - 11/2016]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - 11/2016]

   Body Electrical > Blind Spot Monitor Master > Clear DTCs 

2. Recheck for DTCs and check if the same DTC is output again.

   Body Electrical > Blind Spot Monitor Master > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - 11/2016] 

Result:  2

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to  REMOVAL [12/2013 - 11/2016]