Removal [02/2014 - 11/2016]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE INTAKE MANIFOLD
Refer to REMOVAL [02/2014 - 11/2016]
- REMOVE KNOCK CONTROL SENSOR
- Disconnect the 2 knock control sensor connectors.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
| *A |
for Bank 1 |
| *B |
for Bank 2 |
- Remove the 2 bolts and 2 knock control sensors from the cylinder block sub-assembly.
NOTE:
If the knock control sensor has been struck or dropped, replace it.