LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Lubrication System (2GR-FXS) - Service Information - (Hybrid)) >> Oil Level Sensor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE OIL 

    See step  1

  2. REMOVE FRONT FRAME ASSEMBLY 

    Refer to PROCEDURE - Step 39

  3. SUPPORT AUTOMATIC TRANSAXLE ASSEMBLY 
    1. Set an engine lifter.
      WARNING:

      To prevent the engine assembly with automatic transaxle assembly from falling while servicing, do not remove SST.

      NOTE:

      Make sure that there is clearance between the automatic transaxle assembly and engine lifter.

      GTY719188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE BELT 

    Refer to PROCEDURE - Step 40

  5. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  6. REMOVE OIL STRAINER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 33

  7. REMOVE ENGINE OIL LEVEL SENSOR 
    1. Remove the clip from the engine oil level sensor.
      GTY666622Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts and engine oil level sensor from the oil pan sub-assembly.
      GTY684444Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals