LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Engine Mechanical (2GR-FXS) - Service Information - (Hybrid) (1 Of 2)) >> Rear Crankshaft Oil Seal >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [11/2016 - ]

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
      GTY669149Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.
      GTY645305Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FLYWHEEL SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
      GTY669149Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 8 bolts and flywheel sub-assembly from the crankshaft.
      GTY645315Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE OIL SEAL 
    1. Using a knife, cut through the lip of the rear engine oil seal.
      GTY650816Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Cut Position
      *b Protective Tape
    2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
      NOTE:

      Be careful not to damage the crankshaft.

scientia non olet · About LEMON Manuals