Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL INJECTOR DRIVER

NOTE:

Be careful not to drop or strike the injector driver.

Temporarily install the injector driver to the intake manifold and cylinder head cover sub-assembly LH with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)

Fig 1: Injector Driver Tightening Sequence
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the injector driver connector.

*a	Lock Lever
*b	Injector Driver Connector (with Lock)

Connect the 3 injector driver connectors (with lock) and move the lock lever to engage the lock of each injector driver connector (with lock) as shown in the illustration.
NOTE:
Securely connect the injector driver connectors (with lock) and engage the lock.

INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 74
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [11/2016 - ]
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 70
INSTALL DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 71