Installation [11/2016 - ]: Procedure
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
- Apply a light coat of engine oil to the O-ring.
- Using a 22 mm deep socket wrench, install the PCV valve (ventilation valve sub-assembly) to the cylinder head cover sub-assembly LH.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
NOTE:When reusing the PCV valve (ventilation valve sub-assembly), inspect the O-ring.
- CONNECT VENTILATION HOSE
- Connect the ventilation hose to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.
- INSTALL NO. 1 ENGINE COVER
Refer to PROCEDURE - Step 5
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 74