LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Engine Cooling System (2GR-FXS) - Service Information - (Hybrid)) >> Water Pump >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [11/2016 - ] 

  2. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [11/2016 - ]

  3. REMOVE WATER PUMP PULLEY 
    1. Using SST, hold the water pump pulley.
      GTY624241Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09960-10010 
        1. 09962-01000
        2. 09963-00700
    2. Remove the 4 bolts and water pump pulley.

      HINT: 

      There is not enough clearance to completely remove the water pump pulley from the water pump shaft. Remove the water pump pulley together with the engine water pump assembly.

  4. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 15 bolts, engine water pump assembly, water pump pulley and water pump gasket.
      GTY693329Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals