Data Signal Circuit between Radio Receiver and Stereo Jack Adapter [11/2016 - ]: Procedure

1. Disconnect the F113 radio and display receiver assembly connector.
2. Disconnect the F120 No. 1 stereo jack adapter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Radio and Display Receiver Assembly)
   *b	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F113-2 (US1-) - F120-2 (US1-)	Always	Below 1 Ω
   F113-3 (US1+) - F120-3 (US1+)	Always	Below 1 Ω
   F113-5 (USG1) - F120-5 (UJSS)	Always	Below 1 Ω
   F113-2 (US1-) or F120-2 (US1-) - Body ground	Always	10 kΩ or higher
   F113-3 (US1+) or F120-3 (US1+) - Body ground	Always	10 kΩ or higher
   F113-5 (USG1) or F120-5 (UJSS) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2016 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR