Data List / Active Test [12/2013 - 11/2016]

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Auto High Beam Main Switch	Auto high beam switch signal	ON or OFF	ON: Auto high beam switch pressed OFF: Auto high beam switch not pressed	-
   Dimmer SW	Dimmer switch high position signal	ON or OFF	ON: Dimmer switch in high or high flash position OFF: Dimmer switch in low position	-
   Auto Light SW	Light control switch AUTO position signal	ON or OFF	ON: Light control switch in AUTO position OFF: Light control switch not in AUTO position	-
   Head Light SW (Head)	Light control switch head position signal	ON or OFF	ON: Light control switch in head position OFF: Light control switch not in head position	-
   Light Sensor Illuminance	Light control sensor illuminance	0 to 8191 lx	Value is output according to ambient light levels	-
   Auto H Beam STS0	Automatic high beam sensor current state	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS1	Automatic high beam sensor state past 1	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS2	Automatic high beam sensor state past 2	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS3	Automatic high beam sensor state past 3	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS4	Automatic high beam sensor state past 4	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS5	Automatic high beam sensor state past 5	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS6	Automatic high beam sensor state past 6	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   Auto H Beam STS7	Automatic high beam sensor state past 7	Undetec, CAM NA, No sens, Hlight, Taillgt, Speed, Daytime, Village, Malfunc	Condition can be displayed	Undetec: undetected CAM NA: camera detection malfunction*1 No sens: no detection Hlight: oncoming vehicles with headlights on Taillgt: preceding vehicles with taillights on Speed: vehicle speed Daytime: daytime state Village: urban area Malfunc: system delay
   The Number of DTC	Number of trouble codes	0 to 255	Condition can be displayed	-
   *1: If CAM NA is displayed, the lane departure warning camera may have stopped operating due to high temperature.