Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL TCM

Temporarily install the TCM to the automatic transaxle assembly with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Torque: 11.3 N*m (115 kgf*cm, 8 ft.*lbf)

Fig 1: Tightening Sequence Of TCM Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the TCM connector.

INSTALL AIR CLEANER CASE SUB-ASSEMBLY
Refer to PROCEDURE - Step 54
INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Refer to PROCEDURE - Step 55
INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 3
INSTALL INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 57
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2013 - 11/2016]
CHECK AUTOMATIC TRANSAXLE SYSTEM
NOTE:
If automatic transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

Refer to PRECAUTION [12/2013 - 11/2016]