Typical Enabling Conditions
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor runs whenever the following DTCs are not stored |
None |
| All of the following conditions are met |
- |
| Time after engine start |
5 seconds or more |
| Command to injector driver relay |
On |
| Output duty cycle |
More than output duty cycle change map value*, and less than 95% |
| Auxiliary battery voltage |
10.5 V or higher |
| Power switch |
On (IG) |
| *: Output duty cycle change map value |
- |
| Engine speed is 500 rpm |
5% |
| Engine speed is 2000 rpm |
20% |
| Engine speed is 4000 rpm |
40% |
| Engine speed is 6000 rpm |
60% |
| Engine speed is 8000 rpm |
80% |