LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FE) (Service Information) (Except Hybrid) >> Crankshaft Position Sensor >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

  1. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY 

    Refer to REMOVAL [12/2013 - 11/2016]

  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
      GTY144955Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the crankshaft position sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals