LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) (Except Hybrid) >> Navigation Receiver >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016] Refer to INITIALIZATION [11/2016 - ]

  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 23

  3. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 24

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 26

  6. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET 
    1. Remove the 4 bolts.
      GTY452215Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 2 claws and 2 clips.
      GTY452216Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect each connector and remove the navigation receiver assembly with bracket.
  7. REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio) 

    Refer to PROCEDURE - Step 8

  8. REMOVE NO. 1 RADIO RECEIVER BRACKET 
    1. Remove the 3 screws and No. 1 radio receiver bracket.
      GTY431935Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 RADIO RECEIVER BRACKET 
    1. Remove the 3 screws and No. 2 radio receiver bracket.
      GTY452170Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NAVIGATION RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals