DTC C2176/76: Receiver Error [02/2014 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [02/2014 - ]

   Chassis > Tire Pressure Monitor > Clear DTCs 

2. Turn the power switch off.
3. Turn the power switch on (IG) and check for DTCs.

   Refer to DTC CHECK / CLEAR [02/2014 - ]

   Chassis > Tire Pressure Monitor > Trouble Codes 

   OK

   DTC C2176/76 is not output.

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER. Refer to  REMOVAL [02/2014 - ]