LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tire Pressure Warning System (Service Information) (Hybrid) >> Tire Pressure Warning Valve >> Removal [02/2014 - ] >> Procedure

Removal [02/2014 - ]: Procedure

  1. REMOVE WHEEL ASSEMBLY 
  2. REMOVE FULL SIZE SPARE TIRE (w/ Full Size Spare Tire) 
  3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER 
    1. Remove the tire valve cap.
      NOTE:

      Keep the removed tire valve cap.

    2. Remove the valve core to release the air from the tire.
      NOTE:

      Make sure that a sufficient amount of air has been released.

    3. Remove the nut and washer.
    4. Drop the tire pressure warning valve and transmitter with grommet into the tire.

      HINT: 

      The grommet may remain attached to the rim.

    5. Using a tire remover, remove the tire from the disc wheel.
      GTY441059Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Tire
      *a Shoe
      *b 10 to 20 mm (0.394 to 0.787 in.)
      NOTE:
      • Be careful not to damage the tire pressure warning valve and transmitter due to interference between the tire pressure warning valve and transmitter and the tire bead.
      • Set the tire remover shoe as shown in the illustration.
    6. Take out the tire pressure warning valve and transmitter with grommet from the tire.
    7. Remove the grommet from the tire pressure warning valve and transmitter.
scientia non olet · About LEMON Manuals