Inspection [02/2014 - ]: Procedure
- INSPECT FRONT STABILIZER LINK ASSEMBLY
- Inspect the turning torque of the ball joint.
- Secure the front stabilizer link assembly in a vise using aluminum plates.
- Install the nut to the front stabilizer link assembly stud.
- Using a torque wrench, turn the stud continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
Turning Torque
0.05 to 1.96 N*m (0.6 to 19 kgf*cm, 0.5 to 17 in.*lbf)
HINT:
If the turning torque is not within the specified range, replace the front stabilizer link assembly with a new one.
- Inspect the dust cover.
- Check that the dust cover is not cracked and that there is no grease on it.
HINT:
If the dust cover is cracked or there is grease on it, replace the front stabilizer link assembly with a new one.
- Check that the dust cover is not cracked and that there is no grease on it.
- Inspect the turning torque of the ball joint.