Installation [02/2014 - 11/2016]: Procedure

1. Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.
2. Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.
   Fig 1: Tightening Sequence Of Front Lower No. 1 Suspension Arm Sub-Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Bolt 1, 2 

   Torque: 200 N*m (2039 kgf*cm, 148 ft.*lbf) 

   Bolt 3 

   Torque: 135 N*m (1377 kgf*cm, 100 ft.*lbf) 

   NOTE:

   Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

Refer to PROCEDURE - Step 15 , or refer to PROCEDURE - Step 14

Refer to PROCEDURE - Step 18 , or refer to PROCEDURE - Step 17