Installation [11/2016 - ]: Procedure
- INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
- Install the front seat belt anchor plate as shown in the illustration.
- Install the front seat inner belt assembly LH with the nut.
Protruding Part Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
NOTE:Do not allow the anchor part of the front seat inner belt assembly LH to overlap the protruding part of the front seat adjuster.
- Engage the clamp.
- Connect the connector.
- Engage each clamp under the front seat assembly.
- Install the front seat belt anchor plate as shown in the illustration.
- INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
- Install the front seat belt anchor plate as shown in the illustration.
- Install the front seat inner belt assembly RH with the nut.
Protruding Part Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
NOTE:Do not allow the anchor part of the front seat inner belt assembly RH to overlap the protruding part of the front seat adjuster.
- Connect the connector.
- Engage each clamp under the front seat assembly.
- Install the front seat belt anchor plate as shown in the illustration.
- INSTALL FRONT SEAT CUSHION SHIELD (for Driver Side)
Refer to PROCEDURE - Step 26
- INSTALL VERTICAL ADJUSTING HANDLE (for Driver Side)
Refer to PROCEDURE - Step 28
- INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Driver Side)
Refer to PROCEDURE - Step 29
- INSTALL FRONT SEAT ASSEMBLY
Refer to INSTALLATION [11/2016 - ]