Installation [02/2014 - 11/2016]: Procedure

1. Engage the pin to install the seat position airbag sensor to the seat slide position sensor protector as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the "TORX" bolt and nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Seat Position Airbag Sensor
   *a	Feeler Gauge
   *b	1.3 mm (0.0512 in.)
   *c	Seat Rail

   NOTE:

   • If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
   • When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.
3. Using a T30 "TORX" socket wrench, tighten the "TORX" bolt and nut.

   "TORX" Bolt 

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

4. Make sure that the clearance between the seat position airbag sensor and seat rail is 1.3 mm (0.0512 in.).
5. Connect the connector.
6. Install the wire harness to the 2 clamps.
7. Check that there is no looseness in the installed parts of the seat position airbag sensor.

Refer to INSTALLATION [02/2014 - 11/2016]

Refer to DTC CHECK / CLEAR [02/2014 - ]