LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Service Information) (Hybrid) >> Front Seat Side Airbag Assembly >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY 
    1. Install the front seat airbag assembly with 2 new nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

      WARNING:
      • The nuts must not be reused.
      • Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.
    2. Engage the 2 clamps.
  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD 

    for Manual Seat: Refer to PROCEDURE - Step 20

    for Power Seat: Refer to PROCEDURE - Step 28

  3. INSTALL FRONT SEAT HEADREST SUPPORT ASSEMBLY 

    for Manual Seat: Refer to PROCEDURE - Step 21

    for Power Seat: Refer to PROCEDURE - Step 29

  4. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY 

    for Manual Seat: Refer to PROCEDURE - Step 22

    for Power Seat: Refer to PROCEDURE - Step 30

  5. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Manual Seat) 

    for Driver Side: Refer to PROCEDURE - Step 24

    for Front Passenger Side: Refer to PROCEDURE - Step 25

  6. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Power Seat) 

    for Driver Side: Refer to PROCEDURE - Step 40

    for Front Passenger Side: Refer to PROCEDURE - Step 41

  7. INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD (for Power Seat) 

    Refer to PROCEDURE - Step 37

  8. INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat) 

    for Driver Side: Refer to PROCEDURE - Step 26

    for Front Passenger Side: Refer to PROCEDURE - Step 27

  9. INSTALL FRONT SEAT CUSHION SHIELD (for Power Seat) 

    for Driver Side: Refer to PROCEDURE - Step 38

    for Front Passenger Side: Refer to PROCEDURE - Step 39

  10. INSTALL VERTICAL ADJUSTING HANDLE (for Driver Side Manual Seat) 

    Refer to PROCEDURE - Step 28

  11. INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat) 

    Refer to PROCEDURE - Step 29

  12. CONNECT SEPARATE TYPE FRONT SEATBACK COVER 

    for Manual Seat: Refer to PROCEDURE - Step 30

    for Power Seat without Climate Control Seat System: Refer to PROCEDURE - Step 42

    for Power Seat with Climate Control Seat System: Refer to PROCEDURE - Step 43

  13. INSTALL FRONT SEAT ASSEMBLY 

    for Manual Seat: Refer to INSTALLATION [11/2016 - ]

    for Power Seat: Refer to INSTALLATION [11/2016 - ]

  14. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [02/2014 - ]

scientia non olet · About LEMON Manuals