DTC P3147-240: Transmission system; DTC P3147-242: Transmission system [02/2014 - ]: Procedure
- CHECK DTC OUTPUT (HYBRID CONTROL)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Check for DTCs.
Powertrain > Hybrid Control > Trouble Codes
Result
Proceed to P3147-240 or P3147-242 only is output. P0A1D is also output. - Turn the power switch off.
Result: 1
P3147-240 or P3147-242 only is output.
REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY. Refer to COMPONENTS [02/2014 - 11/2015] Refer to COMPONENTS [11/2015 - 11/2016] Refer to COMPONENTS [11/2016 - ]
Result: 2
P0A1D is also output.
GO TO DTC CHART (P0A1D). Refer to DIAGNOSTIC TROUBLE CODE CHART [02/2014 - 11/2015] Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2015 - 11/2016] Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2016 - 10/2017] Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2017 - ]