DTC P0A4B-253: Generator Position Sensor Circuit [02/2014 - 11/2015]: Procedure
- CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR)
Refer to PROCEDURE - Step 3
Result
Result Proceed to OK A NG (The connector is not connected securely.) B NG (The terminals are not making secure contact or are deformed, or water or foreign matter exists in the connector.) C Result: 2
B
CONNECT SECURELY
Result: 3
C
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
A
See step 2
- CHECK HARNESS AND CONNECTOR (INVERTER WITH CONVERTER ASSEMBLY - GENERATOR RESOLVER)
See step 3
Result
Proceed to OK NG Result: 2
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
OK
See step 3
- CHECK GENERATOR RESOLVER
See step 4
Result
Proceed to OK NG Result: 2
NG
See step 5
Result: 1
OK
See step 4
- CHECK CONNECTOR CONNECTION CONDITION (GENERATOR RESOLVER CONNECTOR)
See step 9
Result
Result Proceed to OK A NG (The connector is not connected securely.) B NG (The terminals are not making secure contact or are deformed, or water or foreign matter exists in the connector.) C Result: 1
A
REPLACE INVERTER WITH CONVERTER ASSEMBLY. Refer to COMPONENTS [02/2014 - 11/2016]
Result: 2
B
CONNECT SECURELY
Result: 3
C
REPAIR OR REPLACE HARNESS OR CONNECTOR
- CHECK CONNECTOR CONNECTION CONDITION (GENERATOR RESOLVER CONNECTOR)
See step 16
Result
Result Proceed to OK A NG (The connector is not connected securely.) B NG (The terminals are not making secure contact or are deformed, or water or foreign matter exists in the connector.) C Result: 2
B
CONNECT SECURELY
Result: 3
C
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
A
See step 6
- INSPECT HYBRID VEHICLE TRANSAXLE ASSEMBLY (GENERATOR RESOLVER)
See step 17
Result
Proceed to OK NG Result: 1
OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 2
NG
REPLACE HYBRID VEHICLE GENERATOR ASSEMBLY. Refer to COMPONENTS [02/2014 - 11/2015]