Caution / Notice / Hint

HINT: 

• If it is necessary to replace the battery voltage sensor, voltages need to be confirmed after installing the new battery voltage sensor. Confirm that "Power Resource VB", "VL-Voltage before Boosting", and "VH-Voltage after Boosting" in the Data List are 320 V or more with the power switch on (READY), the shift lever in P, and the engine stopped. When the system is normal, the "Power Resource VB", "VL-Voltage before Boosting", and "VH-Voltage after Boosting" values should be almost equal (voltage boosting will not occur when the shift lever is in N). If the difference between each voltage exceeds the values specified below, there is a malfunction.

  Inspection voltage	Maximum voltage difference
  Difference between "Power Resource VB" and "VL-Voltage before Boosting"	34 V
  Difference between "Power Resource VB" and "VH-Voltage after Boosting"	31 V
  Difference between "VL-Voltage before Boosting" and "VH-Voltage after Boosting"	42 V

• After the repair, if "VL-Voltage before Boosting" and "Power Resource VB" are approximately the same when the power switch is turned on (READY) with the shift lever in P and the accelerator pedal not depressed, the condition is judged as normal.