DTC B14B3: Lost Communication with Rear Panel LIN [02/2014 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING CONTROL ASSEMBLY - IG POWER SOURCE)
- Disconnect the U1 No. 2 air conditioning control assembly connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition U1-6 (IG) - Body ground Power switch off Below 1 V U1-6 (IG) - Body ground Power switch on (IG) 11 to 14 V Result
Proceed to OK NG
Result: 2
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
OK
See step 2
- CHECK HARNESS AND CONNECTOR (NO. 2 AIR CONDITIONING CONTROL ASSEMBLY - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition U1-7 (E) - Body ground Always Below 1 Ω Result
Proceed to OK NG
Result: 2
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
OK
See step 3
- Measure the resistance according to the value(s) in the table below.
- CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - NO. 2 AIR CONDITIONING CONTROL ASSEMBLY)
- Disconnect the F81 air conditioning amplifier assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition U1-12 (RLIN) - F81-16 (RLIN) Always Below 1 Ω U1-12 (RLIN) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result: 2
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result: 1
OK
See step 4
- REPLACE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY
- Replace the No. 2 air conditioning control assembly.
Refer to REMOVAL [02/2014 - ]
HINT:
Since the No. 2 air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the No. 2 air conditioning control assembly with a new or known good one and check that the condition returns to normal.
OK
No. 2 air conditioning control assembly operation returns to normal.
Result
Result Proceed to OK A NG (When troubleshooting according to Problem Symptoms Table) B NG (When troubleshooting according to the DTC) C
Result: 1
A
END (NO. 2 AIR CONDITIONING CONTROL ASSEMBLY WAS DEFECTIVE)
Result: 2
B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [02/2014 - 11/2016] Refer to PROBLEM SYMPTOMS TABLE [11/2016 - ]
Result: 3
C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to REMOVAL [02/2014 - ]
- Replace the No. 2 air conditioning control assembly.