Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2016 - ]
REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 2
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [11/2016 - ]
REMOVE COMBINATION METER ASSEMBLY
Refer to REMOVAL [02/2014 - ]
REMOVE FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 7
REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 8
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 11
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 15
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 16
DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 17
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 18
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY
Refer to PROCEDURE - Step 22
REMOVE CONSOLE BOX ASSEMBLY
Refer to REMOVAL [02/2014 - ]
REMOVE NO. 2 SWITCH HOLE BASE
Refer to PROCEDURE - Step 30
REMOVE FRONT NO. 2 CONSOLE BOX INSERT
Refer to PROCEDURE - Step 31
REMOVE CONSOLE BOX INSERT
Refer to PROCEDURE - Step 32
REMOVE FRONT DOOR SCUFF PLATE RH
Refer to PROCEDURE - Step 23
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 19
DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Refer to PROCEDURE - Step 35
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 39
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 40
REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 41
REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Refer to PROCEDURE - Step 42
REMOVE INSTRUMENT CLUSTER FINISH PANEL END
Refer to PROCEDURE - Step 43
REMOVE INSTRUMENT PANEL FINISH PLATE
Refer to PROCEDURE - Step 44
REMOVE NO. 1 SWITCH HOLE BASE
Refer to PROCEDURE - Step 46

REMOVE POWER SWITCH

Disengage the 2 claws and remove the power switch from the No. 1 switch hole base.