LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Emission Control System (2GR-FXS) - Service Information - (Hybrid)) >> Purge Valve >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT PURGE VALVE (PURGE VSV) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 23 to 26 Ω

      If the result is not as specified, replace the purge valve (purge VSV).

    2. Apply auxiliary battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).
      GTY716186Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Port (E)
      *b Port (F)
      *c Air
      *d Component without harness connected
      (Purge Valve (Purge VSV))

      OK

      Measurement Condition Specified Condition
      Auxiliary battery voltage applied between terminals 1 and 2 Air flows from port (F)
      Auxiliary battery voltage not applied between terminals 1 and 2 Air does not flow

      If the result is not as specified, replace the purge valve (purge VSV).

scientia non olet · About LEMON Manuals