LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Emission Control System (2GR-FXS) - Service Information - (Hybrid)) >> EGR Valve >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT EGR VALVE ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY454368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without wire harness connected
      (EGR Valve Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      5 (+B2) - 4 (EGR1) 20°C (68°F) 18 to 22 Ω
      5 (+B2) - 6 (EGR3)
      2 (+B1) - 1 (EGR4)
      2 (+B1) - 3 (EGR2)

      If the result is not as specified, replace the EGR valve assembly.

scientia non olet · About LEMON Manuals