LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Cooling System (2GR-FXS) - Service Information - (Hybrid)) >> Temperature Switch >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE COOLANT (for Engine) 

    See step  1

  2. REMOVE HEATER COVER 

    Refer to PROCEDURE - Step 7

  3. REMOVE TEMPERATURE SWITCH 
    1. Disconnect the temperature switch connector.
      GTY424971Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. GTY424973Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Using a 19 mm union nut wrench, remove the temperature switch from the water pipe joint.

      NOTE:

      Do not apply any excessive force to the cooler pipe when removing the temperature switch.

scientia non olet · About LEMON Manuals