LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Cooling System (2GR-FXS) - Service Information - (Hybrid)) >> Radiator >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 11

  2. DRAIN ENGINE COOLANT (for Engine) 

    See step  1

  3. REMOVE COOLER CONDENSER ASSEMBLY 

    Refer to REMOVAL [11/2016 - ]

  4. DISCONNECT NO. 1 RADIATOR HOSE 

    See step  8

  5. DISCONNECT NO. 2 RADIATOR HOSE 
    1. Slide the clip and disconnect the No. 2 radiator hose.
      GTY454731Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. DISCONNECT RADIATOR RESERVE TANK HOSE 

    See step  9

  7. REMOVE RADIATOR ASSEMBLY 
    1. Remove the radiator assembly with the fan shroud assembly from the 2 lower radiator supports.
    2. Remove the 2 lower radiator supports from the vehicle body.
    3. Remove the 2 radiator supports from the radiator assembly.
    4. Disengage the 3 claws.
      GTY451479Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the 3 guides to remove the fan shroud assembly from the radiator assembly.
      NOTE:

      Do not damage the radiator assembly when removing the fan shroud assembly.

scientia non olet · About LEMON Manuals