LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Cooling System (2GR-FXS) - Service Information - (Hybrid)) >> Cooling Fan Motor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 11

  2. DRAIN ENGINE COOLANT (for Engine) 

    See step  1

  3. REMOVE RADIATOR GRILLE 

    Refer to REMOVAL [11/2016 - ]

  4. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 5

  5. REMOVE NO. 3 INVERTER BRACKET 

    Refer to PROCEDURE - Step 6

  6. REMOVE HOOD LOCK ASSEMBLY 

    Refer to PROCEDURE - Step 11

  7. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 8

  8. DISCONNECT NO. 1 RADIATOR HOSE 
    1. Slide the clip and disconnect the No. 1 radiator hose.
      GTY431738Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. DISCONNECT RADIATOR RESERVE TANK HOSE 
    1. Disconnect the radiator reserve tank hose.
      GTY451478Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE FAN SHROUD ASSEMBLY 
    1. Disconnect the 2 cooling fan ECU connectors.
      GTY428755Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 5 wire harness clamps.
    3. Disengage the 3 claws.
      GTY451479Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 3 guides to remove the fan shroud assembly from the radiator assembly.
      NOTE:

      Do not damage the radiator assembly when removing the fan shroud assembly.

  11. REMOVE FAN LH 
    1. Remove the nut and fan LH.
      GTY428764Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE FAN RH 
    1. Remove the nut and fan RH.
      GTY428761Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. REMOVE COOLING FAN MOTOR LH 
    1. Disconnect the cooling fan motor LH connector and disengage the wire harness from the 3 clamps.
      GTY428762Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 screws and cooling fan motor LH.
      GTY443838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE COOLING FAN MOTOR RH 
    1. Disconnect the cooling fan motor RH connector and disengage the wire harness from the 3 clamps.
      GTY428759Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 screws and cooling fan motor RH.
      GTY443837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals