LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Cooling System (2GR-FXS) - Service Information - (Hybrid)) >> Cooling Fan Motor >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL COOLING FAN MOTOR RH 
    1. Install the cooling fan motor RH with the 3 screws.

      Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    2. Connect the cooling fan motor RH connector and engage the wire harness to the 3 clamps.
  2. INSTALL COOLING FAN MOTOR LH 
    1. Install the cooling fan motor LH with the 3 screws.

      Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    2. Connect the cooling fan motor LH connector and engage the wire harness to the 3 clamps.
  3. INSTALL FAN RH 
    NOTE:

    Do not reverse the position of the fan LH and fan RH when installing them. Doing so may damage the parts.

    1. Install the fan RH with the nut.

      Torque: 6.3 N*m (64 kgf*cm, 56 in.*lbf) 

  4. INSTALL FAN LH 
    NOTE:

    Do not reverse the position of the fan LH and fan RH when installing them. Doing so may damage the parts.

    1. Install the fan LH with the nut.

      Torque: 6.3 N*m (64 kgf*cm, 56 in.*lbf) 

  5. INSTALL FAN SHROUD ASSEMBLY 
    1. Engage the 3 guides.
    2. Engage the 3 claws to install the fan shroud assembly to the radiator assembly.
      NOTE:

      Do not damage the radiator assembly when installing the fan shroud assembly.

    3. Engage the 5 wire harness clamps.
    4. Connect the 2 cooling fan ECU connectors.
  6. CONNECT RADIATOR RESERVE TANK HOSE 
    1. Connect the radiator reserve tank hose.
  7. CONNECT NO. 1 RADIATOR HOSE 
    1. Connect the No. 1 radiator hose and slide the clip to secure it.
  8. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  9. INSTALL HOOD LOCK ASSEMBLY 

    Refer to PROCEDURE - Step 2

  10. INSTALL NO. 3 INVERTER BRACKET 

    Refer to PROCEDURE - Step 21

  11. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 6

  12. INSTALL RADIATOR GRILLE 

    Refer to INSTALLATION [11/2016 - ]

  13. ADD ENGINE COOLANT (for Engine) 

    See step  2

  14. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

  15. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 84

scientia non olet · About LEMON Manuals