LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Engine Control System (2GR-FXS) - Service Information - (Hybrid)) >> Throttle Body >> On-Vehicle Inspection [11/2016 - ] >> Procedure

On-Vehicle Inspection [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY 
    1. Put the engine in inspection mode (maintenance mode).

      Refer to INSPECTION MODE PROCEDURE [11/2016 - ]

    2. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

      Standard

      950 to 1050 rpm

      NOTE:
      • Be sure to perform this step with all accessories off.
      • Make sure that the shift lever is in P.
    3. Perform a road test and confirm that there are no abnormalities.
scientia non olet · About LEMON Manuals