Installation [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL SPARK PLUG
HINT:

Perform "Inspection After Repair" after replacing a spark plug.

Refer to INITIALIZATION [11/2016 - ]
1. Install the 6 spark plugs to the cylinder head sub-assembly and cylinder head LH.
  Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
  
  NOTE:
  If a spark plug has been struck or dropped, replace it.
  
  HINT:
  
  Install the same parts to their original positions.
INSTALL IGNITION COIL ASSEMBLY
HINT:

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Refer to INITIALIZATION [11/2016 - ]
1. Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly and cylinder head cover sub-assembly LH with the 6 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  NOTE:
  If an ignition coil assembly has been struck or dropped, replace it.
  
  HINT:
  
  Install the same parts to their original positions.
2. Connect the 6 ignition coil assembly connectors.
INSTALL NO. 1 ENGINE COVER
See step 5
INSTALL EGR COOLER ASSEMBLY
Refer to INSTALLATION [11/2016 - ]
INSTALL AIR SURGE TANK TO INTAKE MANIFOLD GASKET
Refer to PROCEDURE - Step 15
INSTALL INTAKE AIR SURGE TANK ASSEMBLY
Refer to PROCEDURE - Step 16
CONNECT PURGE VALVE (PURGE VSV)
Refer to PROCEDURE - Step 17
CONNECT VENTILATION HOSE
Refer to PROCEDURE - Step 18
INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to INSTALLATION [11/2016 - ]
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 74
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.
  Refer to INITIALIZATION [11/2016 - ]