LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Engine Control System (2GR-FXS) - Service Information - (Hybrid)) >> Heated Oxygen Sensor >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT FLOOR COVER LH 

    Refer to PROCEDURE - Step 3

  2. REMOVE NO. 2 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 12

  3. REMOVE HEATED OXYGEN SENSOR (for Bank 1) 
    1. Disconnect the heated oxygen sensor connector.
      GTY732279Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 3 wire harness clamps.
    3. Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.
      GTY699686Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00012 
      NOTE:

      If the heated oxygen sensor has been struck or dropped, replace it.

  4. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 11

  5. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 15

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY 

    Refer to PROCEDURE - Step 22

  7. REMOVE HEATED OXYGEN SENSOR (for Bank 2) 
    1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
      GTY716789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00012 
      NOTE:

      If the heated oxygen sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals