MIL Circuit [02/2014 - 11/2016]: Procedure

1. Perform troubleshooting in accordance with the table below.

   Result

   Condition	Result	Proceed to
   Power switch on (IG) → Power switch on (READY)	MIL ON→MIL OFF	A
   	MIL does not illuminate	B
   	MIL remains ON	C

Result:  1

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [02/2014 - 11/2016] 

Result:  2

B 

GO TO VC OUTPUT CIRCUIT. Refer to  VC Output Circuit [02/2014 - 11/2016]  

Result:  3

C 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: System Select / Health Check.
5. Check if any DTCs have been detected. Note down any DTCs.

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

   HINT: 

   Check for detected DTCs output from other ECUs which relate to the MIL.

Result:  2

B 

REPAIR CIRCUIT INDICATED BY OUTPUT 

Result:  1

A 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test / Check Engine Indicator.

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Check Engine Indicator

5. Check the status of the MIL while performing the Active Test.

   Result

   Result	Proceed to
   Changes	A
   Does not change	B

Result:  1

A 

REPLACE ECM. Refer to  REMOVAL [02/2014 - 11/2016] 

Result:  2

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [02/2014 - ]