LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FXE) (Service Information) (Hybrid) >> Air Fuel Ratio Sensor >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

  1. REMOVE AIR FUEL RATIO SENSOR (for Bank 2) 
    1. Disengage the wire harness clamp.
      GTY425310Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the air fuel ratio sensor connector.
    3. Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly LH.
      GTY439599Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
      NOTE:

      If the air fuel ratio sensor has been struck or dropped, replace it.

  2. REMOVE MANIFOLD STAY 

    Refer to PROCEDURE - Step 6

  3. REMOVE NO. 1 EGR PIPE 

    Refer to PROCEDURE - Step 7

  4. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 8

  5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1) 
    1. Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly RH.
      • SST: 09224-00010 
      NOTE:

      If the air fuel ratio sensor has been struck or dropped, replace it.

      GTY453295Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals