LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (2GR-FXE) (Service Information) (Hybrid) >> Oil Pressure Switch >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

  1. REMOVE FRONT WHEEL RH 
  2. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 11 , or refer to PROCEDURE - Step 11

  3. SEPARATE FRONT FENDER LINER RH 

    Refer to PROCEDURE - Step 15 , or refer to PROCEDURE - Step 15

  4. REMOVE FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 17 , or refer to PROCEDURE - Step 17

  5. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the wire harness protector.
      GTY429071Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Wire Harness Protector
    2. Disconnect the engine oil pressure switch assembly connector.
    3. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
      GTY308242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals