LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FXE) (Service Information) (Hybrid) >> Cooling Fan Motor >> On-Vehicle Inspection [02/2014 - 11/2016] >> Procedure

On-Vehicle Inspection [02/2014 - 11/2016]: Procedure

  1. INSPECT COOLING FAN MOTOR 
    1. Disconnect the cooling fan motor connector.
    2. Check that the cooling fan motor operates smoothly when the auxiliary battery is connected to the cooling fan motor connector.
      GTY440112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Cooling Fan Motor)
    3. Measure the current while the cooling fan motor is operating.

      Standard Current

      Condition Specified Condition
      Auxiliary battery voltage applied at 20°C (68°F) 15.0 to 21.0 A

      If the result is not as specified, replace the cooling fan motor.

    4. Connect the cooling fan motor connector.
  2. INSPECT NO. 2 COOLING FAN MOTOR 
    1. Disconnect the No. 2 cooling fan motor connector.
    2. Check that the No. 2 cooling fan motor operates smoothly when the auxiliary battery is connected to the No. 2 cooling fan motor connector.
      GTY449091Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 2 Cooling Fan Motor)
    3. Measure the current while the No. 2 cooling fan motor is operating.

      Standard Current

      Condition Specified Condition
      Auxiliary battery voltage applied at 20°C (68°F) 15.0 to 21.0 A

      If the result is not as specified, replace the No. 2 cooling fan motor.

    4. Connect the No. 2 cooling fan motor connector.
scientia non olet · About LEMON Manuals