LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FXE) (Service Information) (Hybrid) >> Cooling Fan Ecu >> On-Vehicle Inspection [02/2014 - 11/2016] >> Procedure

On-Vehicle Inspection [02/2014 - 11/2016]: Procedure

  1. CHECK COOLING FAN SYSTEM 
    1. Check and ensure the following conditions:
      1. The power switch is off.
      2. The engine coolant temperature is less than 94°C (201°F).
      3. The auxiliary battery voltage is between 11 to 14 V.
      4. The A/C switch is off.
    2. Connect the pickup of a clamp-on ammeter around one of the 2 wires for the cooling fan motor.
    3. Turn the power switch ON (IG) and wait for approximately 10 seconds. Check that the fan is not operating.
    4. Start the engine. Check that the fan is not operating with the engine idling.

      HINT: 

      • Make sure that the engine coolant temperature is less than 94°C (201°F).
      • Turn the A/C switch off.
    5. Check that the fan operates when the A/C switch is turned on.
    6. Measure the current while the cooling fan motor is turning.

      Standard Current

      Item Condition Specified Condition
      Cooling fan motor Auxiliary battery voltage applied at 20°C (68°F) 15.0 to 21.0 A
      No. 2 cooling fan motor 15.0 to 21.0 A

      HINT: 

      The engine coolant temperature should be less than 94°C (201°F).

    7. Check that the fan operates when the water temperature sensor connector is disconnected.
    8. Measure the current while the cooling fan motor is turning.

      Standard Current

      Item Condition Specified Condition
      Cooling fan motor Auxiliary battery voltage applied at 20°C (68°F) 15.0 to 21.0 A
      No. 2 cooling fan motor 15.0 to 21.0 A
    9. After the engine is warmed up, check that the fan operates as shown in the illustration.
      GTY451748Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Operating Diagram
      *b MAX HI
      *c HI
      *d LO
      *e OFF
      *f Fan Speed

      HINT: 

      • The engine coolant temperature at which the fan starts operating is approximately 96°C (205°F).
      • This system can also be checked using the Techstream.

        Enter the following menus: Powertrain / Engine / Data List / Coolant Temp.

      Powertrain > Engine > Data List 

      Tester Display
      Coolant Temp
scientia non olet · About LEMON Manuals