Installation [02/2014 - 11/2016]: Procedure

INSTALL POWER MANAGEMENT CONTROL ECU

Install the power management control ECU with the bolt and nut.

Bolt

Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)

Nut

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

HINT:

Tighten the bolt and nut in the order shown in the illustration to install the power management control ECU.

	Bolt
	Nut

INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 32
CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 33
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 34
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 35
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 54 , or refer to PROCEDURE - Step 55
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 55 , or refer to PROCEDURE - Step 56
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 56 , or refer to PROCEDURE - Step 57
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2014 - 11/2016]
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 71 , or refer to PROCEDURE - Step 72
INSTALL DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 72 , or refer to PROCEDURE - Step 73