Hybrid System Indicator Malfunction [11/2016 - ]: Procedure

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [11/2016 - ] .

   Result	Proceed to
   CAN communication DTCs are not output	A
   CAN communication DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM: 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2016 - ] .

Result: 

A 

Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the operation by referring to the table below.

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   HV System Indicator	Hybrid system indicator	OFF, MIN, -50, 0, 100, 200, 300, 400 or MAX	-

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   HV System Indicator

   OK

   Hybrid system indicator indication is normal.

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY: 

Refer to REMOVAL [02/2014 - ] .

Result: 

OK 

Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Check the values by referring to the table below.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   HV System Indicator	Hybrid system indicator value	Min.: -512%, Max.: 511%	-512 to 511%	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   HV System Indicator

   OK

   Hybrid system indicator value displayed on the Techstream is almost the same as the hybrid system indicator indication.

   Proceed to
   OK
   NG

Result: 

NG 

GO TO HYBRID CONTROL SYSTEM: 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2014 - ] .

Result: 

OK 

Go to next step 

1. Replace the combination meter assembly with a new or known good one.

   Refer to REMOVAL [02/2014 - ] .

   OK

   The operation of the hybrid system indicator returns to normal.

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY: 

Refer to REMOVAL [11/2016 - ] .