Entire Combination Meter Does Not Operate [02/2014 - 11/2016]: Procedure

1. Disconnect the F22 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F22-11 (E2) - Body ground	Always	Below 1 Ω
   F22-20 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F22-13 (IG+) - Body ground	Power switch off	Below 1 V
   	Power switch on (IG)	11 to 14 V
   F22-1 (B) - Body ground	Power switch off	11 to 14 V

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY: 

Refer to REMOVAL [02/2014 - ] .

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR