LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Drive Shaft (Service Information) (Hybrid) >> Rear Drive Shaft Assembly >> Inspection [02/2014 - ] >> Procedure

Inspection [02/2014 - ]: Procedure

  1. INSPECT REAR DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY442420Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no excessive play in the radial direction of the inboard joint.
    4. Check the boots for damage.
    5. Check whether each drive shaft dimension (A) is within specification.
      NOTE:

      Keep the drive shaft assembly level during inspection.

      GTY438439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Dimension (A)

      620.2 mm (2.03 ft.)

scientia non olet · About LEMON Manuals