LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Drive Shaft (Service Information) (Hybrid) >> Front Drive Shaft Assembly >> Inspection [11/2016 - ] >> Procedure

Inspection [11/2016 - ]: Procedure

  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY288947Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no excessive play in the radial direction of the inboard joint.
    4. Check the boots for damage.
    5. Check whether each drive shaft dimension (A) is within specification.
      NOTE:

      Keep the drive shaft assembly level during inspection.

      Dimension (A)

      for LH Side 591.75 mm (1.94 ft.)
      for RH Side 938.55 mm (3.08 ft.)
      GTY429366Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for LH Side
      *B for RH Side
scientia non olet · About LEMON Manuals