Brake Control Warning Light Remains ON [11/2016 - ]: Procedure

1. Check if CAN communication system DTCs are output.

   Refer to DIAGNOSIS SYSTEM [11/2016 - ]

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result:  2

B 

INSPECT CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2016 - ] 

Result:  1

A 

See step  2

1. Check if the skid control ECU assembly connector is securely connected.

   OK

   The connector is securely connected.

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

CONNECT CONNECTOR TO SKID CONTROL ECU ASSEMBLY CORRECTLY 

Result:  1

OK 

See step  3

1. Check the auxiliary battery voltage.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   Auxiliary battery	Power switch on (IG)	11 to 14 V
   Auxiliary battery	Power switch on (READY)	11 to 15.5 V

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

CHARGE OR REPLACE AUXILIARY BATTERY 

Result:  1

OK 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the Data List on the Techstream.

   Refer to DATA LIST / ACTIVE TEST [11/2016 - ]

   Chassis > ABS/VSC/TRAC > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ECB Warning Light	Brake warning light / yellow (minor malfunction)	ON or OFF	ON: Warning light on OFF: Warning light off	ECB: Electronically Controlled Brake System

   Chassis > ABS/VSC/TRAC > Data List 

   Tester Display
   ECB Warning Light

4. Check the Techstream display condition of the brake warning light / yellow (minor malfunction).

   Result

   Result	Proceed to
   Display of the Data List remains OFF.	A
   Display of the Data List remains ON.	B

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the parts.

   Refer to PROBLEM SYMPTOMS TABLE [02/2014 - ]

Result:  1

A 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [02/2014 - ] 

Result:  2

B 

REPLACE SKID CONTROL ECU ASSEMBLY. Refer to  REMOVAL [02/2014 - ]